In our forums, our members have been pitting a Srixon ZXi combo against a TaylorMade P7CB/770 combo. WRXer ‘edutch22’ is on the hunt for a new set of irons and kicks off the thread saying:

“Looking at picking up a new set of irons and think I’ve narrowed it down to Srixon ZXi combo or Taylormade P7CB/770 combo. I am currently a 5 cap and allbeit I feel irons are my weakness. My miss is a little to the toe side. I am decently steep at 4-5 down. Always thought I am high spin but recently on trackman my 7 was spinning at 5800 roughly. 

My question or looking for thoughts on which one would benefit me more from a forgiveness standpoint? Or is there another iron is should be looking at entirely? I only get to play about once or twice a week, if I am not playing a 2-3 day event. Thanks in advance.”

And our members have been sharing their thoughts and suggestions in response.

Here are a few posts from the thread, but make sure to check out the entire discussion and have your say at the link below.

• manima1: “You just can’t go wrong with Srixon ZXi7.”
• MattM97: “You have to hit them to know, the V-Sole on the Srixon can be make or break for many.”
• dmeeksDC: “P7CB is more forgiving for me than ZXi7 because my main miss is low middle and the P7CB still flies and spins great on that miss. These are both really nice irons but I like the P7CB more than the Zxi7 and the P770 (or P790) more than the Zxi5. The Srixons are larger so if that gives you confidence that is the way to go. I don’t feel like I get any benefit from the V-sole and the P7CBs live up to their high Maltby forgiveness rating so the TaylorMades have been great for me.”

Entire Thread: “Srixon ZXi combo or TaylorMade P7CB/770 combo? – GolfWRXers discuss”

In our forums, our members have been reacting to a fitting session involving Mizuno’s Pro M13 and Callaway’s X Forged irons. WRXer ‘careergolfer’ recently went through a full fitting session and shared his numbers and commentary, saying:

“After playing Callaway Apex Pros for the pats 5 years, just went through a full iron fitting and thought the data was interesting enough to share. I’ve seen a lot of posts talking about fittings but not many with actual numbers, so here’s mine.

All 7-iron, same ball, same session. Final two were the ones I was choosing between:

The consistency numbers are what actually made the decision:

Callaway won on distance by 3 yards but got there with a much lower ball flight (15.9° launch, 6,144 spin). The Mizuno matched my existing flight profile with nearly 3x tighter ball speed consistency.

Fitter also noted I’ve been setting up with a closed face at address to compensate for a heel-heavy dynamic lie. Ordered the M-13s 1° flat to bring impact back to neutral: the theory being if I can set up square, I can actually commit to the release. I’m not sure if this was the right call TBH but took the fitter’s guidance. I’ll see what happens.

Went with the Mizuno. Clubs aren’t in hand yet. Happy to share follow-up data once I’ve played them!”

And our members have been sharing their thoughts in response.

Here are a couple of posts from the thread, but make sure to check out the entire discussion and have your say at the link below.

• PowerCobra98: “M13 certainly performed well.  Enjoy the new irons once you get them!”
• dmeeksDC: “Two completely different irons. The X Forged is a tour-type iron and would match up with the S3 in the Mizuno lineup. Not going to see a lot of M-13 on pro tours. It’s a crossover iron, three different types of construction in the same set. The M-13 would be more like the AI 150 as the M-13 7 iron is a half-hollow club versus X Forged, which is a straight up forged iron. M-13 middle irons have very thin faces, not holding up well for some buyers if you read through the M-13 thread. Hopefully Mizuno has corrected it. Given the differences in construction, that is surprising ball speed with the X Forged. To me the numbers are quite an endorsement of the X Forged considering it has no ‘tech.'”

Entire Thread: “Mizuno Pro M13 vs Callaway X Forged: My actual fitting numbers – GolfWRXers discuss”